15
NOTE
While changing batteries use only all 8 elements of “type C” produced by the same company,
from same series and condition (all 8 cells are always operable or inoperable altogether).
ALKALINE 1,5V batteries are recommended.
It is highly recommended to convince that all 8 elements have approximately the same charge
level. The assessment can be done with the help of direct-current voltage voltmeter if all 8
elements are manufactured by the same company, marked with the same series and of same
condition.
If the batteries kit has undergone full “life cycle” in the “energy consuming” continuous mode
“Co” it is still likely to be used for quite a long time in “economy” pulse mode “Pu” at “low”
output power (up to 2 hours at the initial power of 5W).
4.6. Illustrative use information about «Power supply monitoring»,
«Buttons functionality», «Symbols»
On the inner side of the cover one can see information on the principle of the following information
types representation, namely POWER SUPPLY MONITORING, BUTTONS FUNCTIONALITY AND
SYMBOLS of the “Digital field” and the front side of the panel
4.7. «Multimeter» of the output parameters
In the “Digital field” during oscillation with the use of “clips” or “clamp” the approximate values
of the output parameters are indicated:
- load signal voltage in volts «
U,V
»;
- load current in amperes «
I,A
» (minimum measured and indicated value – 0,05А «.05»);
- load power in watts «
P,W
»;
- load resistance in ohms or kilohms «
R,(
Ω
/ k
Ω
)
».
In «antenna» modes «In» or «An» only «U,V» is indicated (output signal voltage applied to the
antenna).
The accuracy of measurements is enough for situation assessment at load resistance up to
800
Ω
.
The parameter which value should be indicated in the “Digital field” is set by the “CHOICE”
button «
» in the “Output parameters field” immediately during oscillation process.
Содержание Success AG-511N
Страница 1: ......
