4
Call: 1-631-648-7481 or Visit: support.technocnc.com
5
HD II Tabletop Manual
NK105G2
Call: 1-631-648-7481 or Visit: support.technocnc.com
HD II Tabletop Manual
NK105G2
WARNING!
THE SPINDLE WILL BE DAMAGED
IF UNBALANCED EQUIPMENT IS USED.
AIR SUPPLY MUST BE FILTERED AND DRY.
1.1 - The electronics are housed in the
enclosure located at the back of the machine
displayed in Figure 1.1. The enclosure does
not need to be moved or handled during the
unpacking of the machine.
I. Techno HD II Tabletop Quick Set up
1.2 - Have a suitably qualified person connect power to
the controller. The machine requires 220V single phase
power in order to operate. Plug the power cable into the
rear of the machine as shown in figure 1.2
Fig. 1.1
Fig. 1.2
Fig. 1.3
Fig. 1.4
The customer is responsible to hardwire or install mating plug on supplied
10 ft. wire. You will need to supply your own plug. Have a suitable
qualified person attach the correct plug in compliance with the wiring
standards in your area. The machine must be connected to a 220V, single
phase, 15A circuit.
The cable that we supply will be one of two types.
It may either be a cable with a brown, blue, and green/yellow wire or a
cable with a black, white, and green wire. (Fig 1.3)
Power is connected as follows:
Green or Green/Yellow conductor is always ground .
The two other conductors will be the hot leads.
Connecting the Power
