Call: 1-631-648-7481 or Visit:: www.technocnc.com/technical-support/
15
HD II Tabletop Manual
NK105G2
3.6- Loading a G-code File.
Press the Menu button.
Select “2.USB files” to access the flash drive.
Only a G-code file with an “nc” extension with show.
Scroll through the files with
and
Select file by pressing OK.
Then load the file by pressing 1.
Note:
Files can be copied from this USB to the controller using the “2” button
Local disk space is limited!
Once a file is copied locally, it can also be selected from the jog speed /step size screen
3.7- Running a G-code file.
Once the XYZ origin has been set as per section 3.5 and the file has been loaded as per section 3.6, the
user is ready to run the G-code file.
To run the G-code file simply press the start button
Once the spindle has reached its programmed speed, the machine will move into position to start the
first cut.
The file can be paused while running by pressing
the pause button.
To resume the file press .
To abort the file at any time press .
NOTE:
When the machine pauses, the spindle will stop and the Z axis will move to the Z
clearance/Safe height to allow inspection of the part.
If the machine is jogged off the part during a pause, it will lose its position and when the file is
resumed it will start from the new position.
Loading G-Code file: Before pressing OK (notice that
there is no checkmark)
Loading G-Code file: Notice the check mark next to the
file I want to work with. The check mark appears after
pressing OK. Finally, press 1 to load file, 2 to delete the
file, or 3 to copy it.
