Call: 1-631-648-7481 or Visit:: www.technocnc.com/technical-support/
13
HD II Tabletop Manual
NK105G2
Decrease
Feedrate
Increase
Feedrate
3.3- Modifying the Jog Speed and Step Size.
The machine can be jogged at two speeds, slow and high. You can also change the increments in
which the machine will move in Step mode. These speeds are set in the Manual Parameters page.
To access the Manual Parameters page press OK from the Main Screen (Not menu)
Set the High and Slow speed to a suitable value.
Adjust the Step value as needed.
To Exit out of this screen and return to the main menu press ESC.
When inputting a decimal increment, you must enter the value as 0.### <Zero+(your increment)>
Low Speed
High Speed
Step Sizes
To move the cursor, use the Up and Down directional
arrows.
Enter a new value.
Press OK to accept that value.
3.4- Feedrate Override.
While running a G-Code file, the user can manually override the feedrate or cutting speed of the
program. The range of the override goes from 0% to 120% of the original feedrate.
Example: 50% of 100 IPM = 50 IPM
The user can override the feedrate using the following keys:
Adjust the step size carefully. If you set the step size to
an excessive value, the machine will move by that value
and could damage the machine.
WARNING:
DO NOT MAKE
0% OR
THE MACHINE
WILL NOT MOVE
The value being changed
will be highlighted as
shown
