Technische Alternative UVR610K, Руководство по установке

Страница: 7 / 24

7
Terminal diagram
View of the upper enclosure section with terminals
Jumper setting J1 and J2
The jumpers of the UVR610K(-OD) are located in the cover electronics (see page 17 for graphic).
Jumper J2 changes the function of analogue output A7 to a 24 V output for supplying ex -
ternal devices. In the position shown (at the top), the analogue output is active.
Jumper
J1 changes the function of analogue output A9 to an M-Bus interface. In the po -
sition shown (at the top), the analogue output is active.
Mains connection
Power is supplied through a power supply unit integrated into the module. The mains connection
must therefore be 230 V 50 Hz. This is also the voltage conducted by the output relay. The integral
power supply unit also supplies power to the CAN bus.
Mains:
L...
Phase conductor
N... Neutral conductor
Outputs:
C...
Root
A1 - A6... NO contact
NC... N/C contact A6
N... Neutral conductor
L1... Phase conductor output
Se
ns
or
in
pu
ts
CAN-Bus
an
al
og
ue
o
ut
pu
ts
24
V,
M
-B
us
, D
L-
Bu
s
Sw
itc
hi
ng
o
ut
pu
ts