37
Reset
Pressing the reset button on the front of the CAN monitor
briefly
(with a narrow-tip pen) and releasing
it
before
the beep ends will restart the CAN monitor (= reset).
Loading the firmware with the factory settings
In special cases, it may be necessary to restore the CAN moni-
tor's
firmware
to its condition when delivered from the factory.
A
total reset is carried out at the same time.
Pressing the reset button on the front of the CAN monitor (with a
narrow-tip pen)
when switching it on
will initiate loading of the
original firmware at the time of delivery.
The button must be pressed until the beep stops.
Calibration
If the touch-sensitive points on the touchscreen no longer align with the background graphics, making
it difficult to operate the CAN monitor, you can re-adjust the touchscreen using "
Calibration
".
You can start calibration by pressing the
touchscreen surface
when the TA logo is displayed
after the
monitor is started.
The following display appears for five seconds after the monitor is started (the seconds will count
down):
Touching the screen within that time will
start the calibration procedure.
To calibrate, you must touch all 9 target
points separately one after the other.
You then have the option of a total reset or
continuing to the main menu of the CAN
monitor.
Reset button
Touch the screen for calibration
5 sec
