5
- once released from the three springs, the
glass can be extracted from the lower seat
of the inside of the door.
- Fix the handle using the 2 screws provi-
ded.
After fi tting oven door handle, repeat the
same procedure in reverse order.
- fi t the glass into the lower seat of the in-
side of the door.
- press gently on the upper side of the glass
so that the three pins, with silicone on the
inside, fi t into their holes.
- make sure that the door closes complete-
ly.
CONNECTING TO THE GAS SUPPLY
Before connecting the cooker, check that it
is preset for the gas to be used. Otherwise,
make the conversion as described in the
section headed "Adapting to different gas
types". The appliance is factory set for
Natural gas. The test point pressure should
be adjusted to 1.00kPa with the Wok
burner operating at maximum. Ensure that
the gas regulator supplied with the cooker
is connected as close as practical to the
gas inlet. The gas connection is male 1/2
BSP and is situated at the right hand rear
of the appliance, 545mm from the bottom of
the cooker ( without legs ) and 34mm from
the RHS. See fig. 3
- For ease of service, the cooker should
be connected with a flexible hose .Ensure
the flexible hose complies with AS/NZS
1869 ((Australian Certified), 10mm ID,
class B or D, between 1 - 1.2m long and is
installed in accordance with AS/NZS 5601
for a high level connection. The hose
should not be subjected to abrasion,
kinking or permanent deformation and
should be able to be inspected along its
entire length. Unions compatible with the
hose fittings must be used and connections
tested for gas leaks. The fixed consumer
piping outlet should be at approximately the
same height as the cooker connection
point, pointing downwards and
approximately 150mm to the side of the
cooker. The hose should be clear of the
floor when the cooker
is in the installed position.
The installer must supply and install a restrain-
ing device (typically chain) utilising the anchor
point provided for the anti tilt chain closest
to the gas connection point. This restraining
device must restrict the appliance movement
to no more than 80% of the hose length to
prevent strain on the hose connections when
the cooker is pulled forward.
- Alternatively, the cooker can be
connected with rigid pipe as specified in
AS/NZS 5601
-
After installation, check that all
connections are airtight.
- For operation with
Universal LPG
, check
that the gas pressure is as indicated on
the nameplate.
ADAPTING TO DIFFERENT TYPES OF
GAS
If the cooker is not already preset to operate
with the type of gas available, it must be con-
verted. Proceed as follows:
- Replace the injectors ( table on page 3);
- regulate the primary air fl ow;
- regulate the minimum settings.
N.B.: every time you change the type of
gas, indicate the new type of gas on the
serial number label. When converting from
Natural Gas to Universal LPG ensure that
the NG regulator is removed and replaced
with the Test Point Assembly. A gas
regulator suitable for a supply pressure of
2.75kPa should be part of the gas tank
supply.
REPLACING THE HOB BURNER INJEC-
TORS (Fig. 6)
- Remove the grid, the burner caps
(A)
, and
the burners
(B)
;
- Unscrew and remove the injector in the
bottom of each injector holder
(C)
;
- replace the injector in accordance with the ta-
ble in page 3, tighten and screw right down;
- check that the system is gas-tight;
- replace the burners, the burner caps and the
grid.
Installation
AU
