7
burning match towards the burner; IT
MUST NOT IGNITE.
Time needed to excite the magnet during
igni-tion: 10 seconds approx.
Automatic tripping time, after fl ame has
been turned off: not more than 90 seconds
for hob burners; not more than 60 seconds
for oven and grill burners.
IMPORTANT:Before doing any work inside
the cooker, disconnect the mains plug and
shut the gas tap.Never use matches to
check the gas circuit for leaks. If a specifi
c control device is not available, foam or
very soapy water can be used.When re-
closing the hob, check that the electrical
wires of the spark plugs (if present) are not
close to the injectors, so that they can-not
run across them.
HOW TO USE THE COOKER
VENTILATION
All gas cooking appliances produce heat
and moisture in the rooms where they are
installed. Take care to ensure that the
kitchen is well ventilated; keep the ventilation
openings unobstructed or install an extractor
hood with fan.
In case of intensive or prolonged use, ad-
ditional ventilation may be required; open
a window, or increase the extractor fan
power.
-
IGNITING THE HOB BURNERS
To light the burner, press the control knob
fully down and hold the knob down before
rotating anti-clockwise to the high flame
position. The ignition device is integrated
into the control knob and is automatically
activated by pushing down on the control
knob.
After lighting the flame, keep the knob
pressed for about 10 seconds: this is
necessary to heat up the thermocouple
and activate the safety valve, which would
otherwise cut off the gas flow. this step
only applies where flame failure device is
fitted.
In the instance of a power failure, place a
lit match near the burner and proceed as
described above. If the flame does not
light after first attempt, wait 5 minutes for
the gas to dissipate before attempting to
re-light the burner.
Once lit, check that the flame is even and
turn the control knob to adjust the flame as
required. if the flame is uneven, check that
the 'burner head/ skirt' and 'burner cap'
are correctly positioned. To turn off the
flame, turn the control knob clockwise to
the off position.
(
symbol)
Before
removing po
ts
or
pans from the burners,
always turn off the
flame.
AU
For the user
Installation
Check all connections for gas leaks with
soap and water.
DO NOT
use a naked
flame for detecting leaks. Ignite all
burners both individually and
concurrently to ensure correct operation
of gas valves, burners and ignition. Turn
gas taps to low flame position and
observe stability of the flame for each
burner individually and concurrently.
When satisfied with the appliance,
please instruct the user on the correct
method of operation. In case the
appliance fails to operate correctly after
all checks have been carried out, refer to
the authorised service provider in your
area.
-
BEFORE LEAVING
