Technik-Plus FRONT-TURBO, Инструкция по эксплуатации

Страница: 16 / 29

16
PROFI CONTROL UNIT
Speed knob:
For adjusting the speed on the seed roll motor=adjusting of output amount. The amount cann be
changed during operation
The seed roll motor speed = output amount can be adjusted stepless with this Poty . This can be done during
operation too to get the correct output amount. (Because of technical reason 0-3 without function.)
Calibration of the seeder:
Before start working the seeder must be calibrated. Note this adjustings for future operations (driven speed,
output amount, working width, poty adjustment, ...). Keep the fan turned off. Open the bottom flap on the
seeder (two spanner nuts). Let the flap hang downwards and put a vessel for collection below. (Be sure that
you have weighed this vessel). Fill in a small amount of seed into the seeder and close the hopper cover. Now
switch the seed roll on (Main switch to on and choosing a poty position, press the red button). Collect the
seed for 1 minute and weigh it accurate. The seed roll flap must be in correct position! Now calculate with
following formula how many kg per min have to be in the vessel.
Working width x Driven speed x Output amount/Ha
600
z.B.:
6m x 7km/h x 20kg/ha
600
6 x 7 = 4,2 ha/h x 20 kg/ha = 84 kg Output amount/h : 60 min
Is an amount of 1,4 kg/min which should be in your vessel.
z.B.: You know the working width, the driven speed and the output amount per hectare. As above mentioned
you can put in the different values into the formula and you get the needed amount. During calibration the
seed roll motor must run with the same speed during operation. Keep the cover closed! Is the calibration
done, close the bottom flap with the two spanner nuts.
1
= Output amount in kg/min
= 1,4 kg/min
1
2
3
4
Cable to
seeder
Battery cable
5
On-/Off-sensor