Page
9
of
23
4 Status LEDs and Pushbutton
The BR SPY mini has several status LEDs at the front side of the case.
The “Host” LED1 must be ON, and “Host” LED2 must toggle slowly (approx. 1 sec).
If LED2 does not toggle or LED1 is OFF, an error has been detected by the Host.
The “FPGA” LED1 and LED2 show the setting of the DIP switches 3 and 4. When one of
these switches is ON, the corresponding LED is ON.
The 4 BR Link LEDs 1A to 2B monitor the link status of the ports BR1A to BR2B. The LEDs
are lit when there is BroadR-Reach link detected. These LEDs are updated in real time.
Note:
There is an issue when P/N of the bus are swapped. The LED may be on in this case
on BroadR-Reach slave side, but there will be no data transmission possible.
The built-in LEDs in RJ45 connector shows the status of the gigabit ports. The left (orange
LED) is lit by a link-up. The right (yellow) will blink on data traffic.
