13
4-9. Wireless Remote Controller
Installation
The remote controller can be operated from either a non-
fixed position or a wall-mounted position.
To ensure that the air conditioner operates correctly, do not
install the remote controller in the following places:
• In direct sunlight.
• Behind a curtain or other place where it is covered.
• More than 8 m away from the air conditioner.
• In the path of the air conditioner’s airstream.
• Where it may become extremely hot or cold.
• Where it may be subject to electrical or magnetic
interference.
■
REMOVABLE MOUNTING
•
Heat pump models
Raise the rear plate of the remote controller mounting cradle
and insert the remote controller. The unit can be used either
in that position (placed on a table, for instance) or held in the
hand. (Fig. 4-10).
•
Cooling only models
1)
Momentarily hold the remote controller at the desired
mounting position.
2)
Confirm that the air conditioner responds correctly when
you press keys on the remote controller from that
position.
3)
After confirming correct operation, use a screw-driver
to screw the supplied special mounting screw into the wall
(Fig. 4-11).
4)
Hang the remote controller from the mounting screw.
Rear plate
Remote control unit
mounting cradle
Remote control unit
Fig. 4-10
Special
mounting
screw
(Packed in
indoor unit)
Wall
Fig. 4-11
■
NON-REMOVABLE MOUNTING
•
Heat pump models
Install the remote controller at a convenient location on a
nearby wall. However, before attaching the remote controller
mounting cradle, check that the remote controller can operate
from the desired wall position. (Fig. 4-12)
•
Cooling only models
1)
Momentarily hold the remote controller at the desired
mounting position.
2)
Confirm that the air conditioner responds correctly when
you press keys on the remote controller from that
position.
3)
After confirming correct operation, use a screw-driver
to screw the mounting screw into the wall.
4)
Remove the remote control cover by sliding it downward.
5)
Remove the batteries of the remote controller.
6)
Use a screwdriver to screw the remote controller securing
screw into the wall through the hole in the battery
compartment. (Fig. 4-13).
7)
Replace the batteries.
8)
Again confirm that the remote controller operates
correctly.
Wood screw
(supplied)
Fig. 4-12
ACL button
Fig. 4-14
Wall
Screw
(Packed in indoor unit)
4-10. How to install batteries (only for heat
pump models).
See fig. 4-14
1)
Press and slide the lid on the back of the remote controller
in the direction of the arrow.
2)
Install two AAA alkaline batteries. Make sure the batteries
point in the direction marked in the battery compartment.
3)
Press the ACL button, then replace the lid. If you press it,
the current time, ON time, and OFF time are all reset to
0:00.
Fig. 4-13
EG
