EG
9
No.
Accompanying parts
Q’ty
Operation controller
1
Indicator section
1
Remote controller
1
Remote controller mounting
1
cradle
Battery
2
•
Outdoor Unit Heat pump models
No.
Accompanying parts
Q’ty
Spacer
2
Instruction Manual
1
Pan-head tapping screw
4
4 x 10
Truss-head tapping screw
2
4 x 16
Vinyl clamp
3
L 150
ALARM MESSAGE LABEL
1
No.
Accompanying parts
Q’ty
Instruction Manual
1
Tapping screw
1
Tapping screw
1
Vinyl clamp L 150
3
Alarm message label
1
No.
Accompanying parts
Q’ty
Operation controller
1
Indicator section
1
Wireless remote controller
1
AAA alkaline battery
1
■
ACCESSORIES
•
Outdoor Unit Cooling only models
4. HOW TO INSTALL THE REMOTE CONTROLLER (OPTIONAL PART)
Run
Timer Heating preparations
Special
screw
4 x 16 mm
TOTA 4 x 16
4-1. Indicator section Installation
• Remove the mark section and install the indicator section.
(1)
Remove the ceiling panel.
(2)
Remove the corner cover behind the mark section. (3 screws)
(3)
Remove the mark section inside the ceiling panel. (2 screws)
(4)
Install the indicator section in the location where the mark section was attached. (2 screws)
(5)
Form the wire to match the panel ribs as in the Fig. 4-2.
(6)
Install the corner cover. (Restrain the wire with the corner cover.)
Air intake grille
Mark section
(indicator section)
Ceiling panel
Corner cover
3 screws
Pass the wiring through under the shaft.
Wiring
Indicator section
2 screws
Fig.4-1
Fig. 4-2
