04/2019 - AE/V1.16
18
Technetix Group Limited
Output splitter selector
Referring to the network design documentation, configure the output splitter by installing a 0 pad/
jumper into the upper three holes of the five holes to pass all RF to Port 1, or use the three lower holes
to pass all RF to Port 2� Alternatively, install a relevant 2-way splitter or directional coupler�
When installing the directional coupler, ensure that it is in the correct way round so the through leg
is passing RF to the correct port as required by the network design documentation for location of
amplifier installation�
With the output selector installed as shown in the picture below, pin 5 is on the bottom, so RF Port
2 has tap leg and RF Port 1 has through leg of selector� To reverse the selection, install the output
selector the other way round�
