AIMA3000.FT5X Product User Manual
Technetix Group Limited
•
technetix.com
May/2016 - Version 1.0
28
5.7 FT5X Initial Setup
1.
Pending finalisation of module.
2. Before installing the FT5X, check the optical output ferrule tip with a fibrescope to ensure that the connector
is clean (pictured below). The cap on the optical output connector does not prevent contamination from ......
getting on to the optical connector, it prevents the laser from being emitted when laser is on and no optical
patch cord is installed.
3. Next install the FT5X unit into a slot where RF input leads are connected and check the optical output power
with a cleaned optical patch cord and a calibrated optical power meter. Record the optical output level. Connect
a cleaned patch cord to the fibre output and to the relevant optical distribution frame (ODF) panel.
4. With a laptop connected to the ASMM module’s network or an Android device connected to the front of the
ASMM module’s USB port in host mode. Select the port for the transmitter that needs to be adjusted, confirm that
the
“Input AGC mode”
is set to
“OFF”
, if not change it to
“OFF”
and then click on
“Submit”
button. In addition,
confirm that the
“RF MGC”
is set to 0.0, if not set to
"0.0"
and click on
“Submit”
button.
5. Confirm in the management
“Status”
section that the RF levels for the inputs and the RF Composite Input Power
are within the designated parameters.
Содержание AIMA3000.FT5X
Страница 52: ...technetix com May 2016 Version 1 0...
