Techne 083010, Инструкция по эксплуатации

Страница: 6 / 39

6
Operator maintenance
NOTE: THAT THIS EQUIPMENT SHOULD ONLY BE DISMANTLED BY PROPERLY TRAINED PERSONNEL.
REMOVING THE SIDE, FRONT OR REAR PANELS EXPOSES POTENTIALLY LETHAL MAINS VOLTAGES.
THERE ARE NO OPERATOR MAINTAINABLE PARTS WITHIN THE EQUIPMENT.
In the unlikely event that you experience any problems with your unit which cannot easily be remedied, you should
contact your supplier and return the unit if necessary. Please include any details of the fault observed and remember
to return the unit in its original packing. Techne accept no responsibility for damage to units which are not properly
packed for shipping: if in doubt, contact your supplier. See the Decontamination Certificate supplied with your unit.
Cleaning
v
Before cleaning your unit ALWAYS disconnect it from the power supply and allow it to cool below 50°C.
v
Your unit can be cleaned by wiping with a damp soapy cloth. Care should be exercised to prevent water
from running inside the unit. Do not use abrasive cleaners.
Over-temperature cut-out
v
In the event of no heater power, check the mains plug and lead.
v
Repeated operation of the cut-out indicates a serious fault: you may need to return the unit to your
supplier for repair.
Fuses
v
Your unit is protected by one or two fuses.
v
These should only be changed by suitably qualified personnel.
v
Replace fuses only with the type listed in the Technical Specification (page 31).
v
If the fuses blow persistently, a serious fault is indicated and you may need to return the unit to your
supplier for repair.