Operation
Turn ON the inverter:
Turn ON/OFF switch on the front panel for some
seconds. The RED LED indicator light will light verifying the inverter is
receiving power
Turn OFF the inverter:
Turn ON/OFF switch on the front panel for some
seconds
When you have confirmed that the appliance to be operated is turned off, plug
an appliance cord into one of the 230V AC outlets on the front panel of the
inverter
⚫
Turn Inverter ON/OFF Switch to the ON position
⚫
Turn the appliance ON.
To disconnect, reverse the above procedure
Note:
If you are going to operate several loads from the inverter, turn them on
separately after you have turned the inverter on. This will ensure that the
inverter does not have to deliver the starting current for all the loads at once.
Using the Inverter to Operate a TV or Audio Device
The inverter is shielded and filtered to minimize signal interference. Despite
this, some interference may occur with your television picture, especially with
weak signals. Below are some suggestions to try and improve reception.
Make sure the television antenna produces a clear signal under normal
operating conditions (i.e. at home plugged into a standard 230 volt AC wall
outlet). Also, ensure that the antenna cable is adequately shielded and of
good quality.
Try altering the position of the inverter, antenna cables, and television power
cord. Add an extension cord from the inverter to the TV so as to isolate its
power cord and antenna cables from the 12 volt power source.
Try coiling the television power cord and the input cables running from the 12
volt power source to the inverter.
Affix one or several “Ferrite Data Line Filters” to the television power cord.
Ferrite Data Line Filters can be purchased at most electronic supply stores.
Try grounding the inverter with a minimum (0.75mm²) wire, using as short a
length as possible.
