2
3
Safety Precautions
Do not raise or lower the hoist when people are under
near or on the top of the hoist or vehicle.
Always watch the vehicle while raising or lowering.
Always consider the vehicle stability before removing or
adding parts.
Do not use the hoist motion for removing or adding
parts.
Some vehicles are not suitable for lifting on a 2 post hoist.
e.g. Toyota Landcruiser 80 series.
Always keep the lifting pads clean and in good condition.
Use only Tecalemit approved lifting accessories.
This hoist is designed for raising vehicles. Do not use it for
any other purpose.
Do not have vehicle engine running on hoist unless
absolutely necessary, to avoid injury from the hot exhaust
or rotating parts.
Always turn the isolating switch to the horizontal “off”
position when stopping the hoist after raising. Switch-
ing to the “off” position will immediately stop the hoist
if there is any malfunction and will isolate the hoist and
protect the operator should the electrics be damaged in
any way.
In an emergency or when servicing, turn the isolating
switch to “O” and padlock it.
Do not directly spray or hose the hoist with water as it will
eventually cause corrosion and shorten the life of the
Contents
Page
Subject
3-5
Installation Instructions
6-7
Operating Instructions
To Raise Hoist
To Lower Hoist
Routine Maintenance
Major Service
8-9
Fault Diagnosis
10-11
Illustrated Parts Lists
hoist. The hoist is not suitable for operations that involve
washing of the vehicle.
(If washing down the floor around the hoist, raise the
arms 200 mm off the floor so the hole in the column
blind is covered by the carriage to prevent any overspray
entering the oil reservoir.)
TEC3000X Statutory Design Approvals and
References
Australia
State
Approval Reference No.
South Australia
SD 97132-1
Western Australia
Refer to S.A.
New South Wales
Not Required
ACT
Refer to S.A.
Northern Territory
Refer to S.A.
Queensland
Q16369
Tasmania
Refer to S.A.
Victoria
Refer to S.A.
Electrical approval
MC1S/AO
(Electricity Trust of SA)
New Zealand
Not Required
