TEC BRST-10 SERIES, Руководство пользователя

Страница: 17 / 28

5-6
5. INSTALLATION PROCEDURE EO1-13013
5.4 INSERTING THE SLIP
NOTES: 1. Setting the slip
• Insert the slip until it fits against the paper feed roller and the slip side guide.
• Setting the slip after the SLIP LED blinks is recommended.
2. Slip paper
• Use the flat paper which is not curled, folded, warped, or wrinkled. Failure to do
this may cause ink smudge resulting from contact with the ink cartridge or a paper
feed error after printing. If the paper end is much curled or folded, the slip paper
may not be set. (In this case, the printer feeds the paper.)
3. Removing the jammed slip
• Check the SLIP LED blinks, and then remove the jammed paper with the [FEED]
switch.
• If the paper cannot be removed with the [FEED] switch, open the printer cover and
pull out the jammed paper manually.
Fig. 5-11
Slip side guide
Paper feed roller
Slip
POWER
FEED
RESET
CART-
RIDGE
SLIP
INKOUT
POWER
ERROR
POWER
FEED
RESET
CART-
RIDGE
SLIP
INKOUT
POWER
ERROR
5.4 INSERTING THE SLIP
1. When the host sends the slip print command to the printer,
the SLIP LED blinks.
Fig. 5-10
Slip
Slip Inlet
2. Insert the slip straight into the slip inlet while aligning the
right side of the slip with the slip inlet.