Tec-Innovation InnoMake v.1, Руководство пользователя

Страница: 22 / 36

TDIM1_4_User Manual_1 22
4.7. Activate intelligent mode
The InnoMake attachment parts are equipped with an intelligent mode that
you can activate at any time. When intelligent mode is activated, an
attachment part detects when the respective shoe is in a resting position.
Should the shoe with the attachment part be in a resting position for 3
seconds, the attachment part will switch to sleep mode and stop providing
instant feedback.
You can activate intelligent mode by pressing the push button on the back of
the attachment part. In order to avoid damaging the casing, do not use too
much force when pressing the push button.
In order to activate or deactivate intelligent mode, press the push button
4 times in quick succession. Your setting adjustment will be confirmed
as follows:
▪
2 long, low tones followed by 1 short, high tone indicate that
intelligent mode is activated
▪
2 long tones followed by 1 short tone in the same pitch indicate that
intelligent mode is deactivated
4.8. Activate LED
The LED on the front side of the attachment parts is located between the two
ultrasonic sensors. If you have activated the LED, it will always light up when
your shoe is in a resting position. Your shoe is in a resting position when you
are standing or walking and your foot is fully on the ground. This improves
visibility, especially in the dark, because a flashing effect is created while
walking.
Please note that when intelligent mode is activated, the LED is also always
automatically deactivated if obstacle detection is paused.
Information on intelligent mode can be found in section 4.7.