TEC Infra-red STERLING, Руководство пользователя

Страница: 13 / 31

If your pilot/spark ignition system is not working
properly, the burner may be ignited manually, using a
match. Use the following procedure to do so.
Procedure:
1. Open the Hood, ensure all valves are closed and that
the cooking surface of the grill is not covered.
2. For LP gas, open the Gas Valve on Cylinder.
For Natural gas, open the Gas Valve in the main
line.
3. Remove the right Cooking Grid. Ignite the match.
Place the match directly on the burner screen above
the right half of the burner.
4. Confirm that the match is still burning. Depress and
turn the right Burner Output Knob to (HIGH).
Once it is lit, depress and turn the left and center(on
Sterling III) burners to (HIGH). If any burner
fails to ignite within 5 seconds, turn the Burner
Output Knob of that burner to OFF, wait five
minutes, then repeat.
5. Operate on (HIGH) until the burners glow
uniformly, then turn the Burner Output Knobs to
desired cooking level.
6. To extinguish the flame, depress and rotate the
Burner Output Knobs and the Pilot Valve Knob to
OFF.
7. For LP gas, close the Gas Cylinder Valve by turning
the Handwheel clockwise. For Natural gas, close the
gas valve in the main line.
Low Heat Adjustment
WARNING:
NEVER ADJUST THE BURNER SO LOW
THAT IT MAY GO OUT DURING USE. DO NOT OPERATE
GRILL WITH DISENGAGED LOW HEAT ADJUSTING
SCREW.
The Low Heat Adjusting Screw only applies to the
burner operation at the LOW setting. Any efforts to
make adjustments at another setting will go unnoticed
until the burner is turned to LOW where it may
involuntarily extinguish while gas is still flowing. This
condition is unsafe and therefore adjustments should
only be made from the LOW setting while keeping a
close eye on changes.
The burner’s LOW heat output is preset at the factory. If
you need to adjust this setting due to a particular cooking
style, follow the instructions below.
Procedure:
1. Follow the Burner Ignition procedures and operate
the grill for 5 minutes or until the ceramic burners
turn red.
2. Turn the Burner Output Knob to the LOW position
and wait until the temperature drops and stabilizes.
3. Remove the Burner Output Knob from the valve
stem. (See Figure 15.)
4. Insert a small blade screwdriver into the valve stem.
5. Turn the Low Heat Adjusting Screw clockwise to
reduce the LOW heat intensity or counter-clockwise
to increase the LOW heat intensity.
Figure 15.
Low Heat Adjustment
Operation
continued
12
Revised 08/04
LOW HEAT
ADJUSTING
SCREW
LEFT BURNER OUTPUT KNOB
SPARK IGNITER KNOB
RIGHT BURNER OUTPUT KNOB
PILOT VALVE KNOB
Figure 14.
Grill Knobs