Team SILK AX08, Инструкция по эксплуатации

Страница: 31 / 66

AX08 Flange Facing and Grooving Machine
30
5.2.3 Setting up the tool - facing and grooving
As the TEAM ® flange facing machine is portable and thus lighter and less rigid than
its workshop counterpart, the choice of tooling and the rate at which metal can be
removed will differ from that used in a workshop.
The following procedure is for setting up the tool for facing full and raised face
flanges and grooving:
1. Observe all Warnings and Cautions; refer to Sections 3 and 5.1.
2. Using the standard toolpost (Figure 9) select the appropriate tool for the job.
3. Install the tool into the toolpost and ensure it is fully engaged, Tool feed is
achieved by the toolpost feed knob.
4. With the tool in position, check that there are no obstructions to the tool and
saddle. Determine the point at which the tool touches the flange, this is
achieved by slowly rotating the machine, and advancing the tool by turning the
toolpost feed knob until it just touches the surface of the flange. Traverse the
tool to an edge and stop the machine.
Figure 15 - Toolpost positions
5.2.4 Selecting the traverse
To select and engage the automatic feed, pull the handle upwards and this will
traverse the toolpost outwards - Figure 8 - Toolpost Movement.
To disengage the automatic feed, push the hand wheel downward and the feed will
stop. Once stopped this will allow manual feed to commence which will traverse
the tool inwards - Figure 8 - Toolpost Movement.