AX08 Flange Facing and Grooving Machine
26
9. Toolkit comprising of:
•
1 set of Allen keys
•
16 mm AF combination spanner
Turning tool and inserts;
•
10mm SQ. Straight tool – Left Hand
•
10mm SQ. Straight tool – Right Hand
•
10mm SQ. Straight tool - Neutral
10. Spare pack of bolts
11. Certificate of Conformity
The machine and its associated equipment should be removed from the case and visually
inspected for signs of wear, damage or corrosion.
The AX08 assembled machine when complete and in its box weighs 33 kg.
The AX08 assembled machine weighs 23 kg.
•
The mounting assembly with four base clamp blocks secured weighs approx. 8 Kg,
•
The Drive ring assembly and saddle weight approx. 8 Kg
•
The Pneumatic Motor weighs approx. 4 Kg
•
Care must be taken when handling these sub-assemblies out of the packing box.
The installation procedure detailed sets up the AX08 in a horizontal position. If the
machine is to set up in the vertical or inverted position follow the set up procedure
but extreme care must be taken due to the greater risk of the machine falling off
the flange during the setting and adjusting procedure.
5.2.2 Drive Ring and Bearing Assembly Installation
The drive ring and bearing assembly is installed on the flange to be machined as
follows:
1. Observe all Warnings and Cautions; refer to Sections 3 and 5.1
2. If supplied, remove the mounting plate
assembly from the drive ring and
bearing assembly by removing the
6 off M5 x 25 screws and washers Figure 3
3. Measure the outside diameter of the flange and position the jaw assemblies
equally within 12mm (0.5") of the flange size. The
spacers must be fitted
Содержание SILK AX08
