2 9
BAG G (Continued)
Figure 62
Figure 63
!
Step 28. Cut a piece of two-sided tape (156) to the same size
as the bottom of the speed control (
not included).
Peel one side of
the backing off and stick the tape (156) to the bottom of the speed
control.
!
Step 29. Make sure that the area on the left side of the
chassis (19) is clean. Wipe this area off with a clean cloth or rag.
*NOTE: Rubbing alcohol can be used to clean any oily residue that
may be present on the chassis or receiver. Allow the alcohol to dry before
applying the two-sided tape.
!
Step 30. Peel the backing off of the two-sided tape (156) and
install the speed control to the left side of the chassis (19) as
shown in Figure 64.
!
Step 31. Run the wire from the speed control through the
slot in the left rail on the chassis (19), across the center of the
chassis (19), and through the slot in the right rail of the chassis
(19).
!
Step 32. Plug the speed control wire into the channel 2 slot
in the receiver. Plug the wire from the servo into the channel 1
slot in the receiver.
Figure 62
!
Step 33. Trim the body (159) along the trim lines as shown
in Figure 63.
!
Step 34. Make five 1/4"-diameter holes in the locations marked
with dimples at the front, rear, and roof of the body (159). These will
be the body mounting and antenna tube holes.
!
Step 35. Remove the spoiler from the rear section of the
body by cutting it out along the trim lines. Attach the spoiler to
the rear of the body with a piece of two-sided tape (156).
!
Step 36. Install the body (159) onto the rolling chassis and
secure it with body clips (155) through the posts (56) on the front
shock tower (24), and through the posts on the rear shock tower
(55).
155
BODY PAINTING
Prepare the Lexan body shell for painting by washing it thoroughly with warm water and liquid detergent. Dry the body with a clean,
soft cloth. Use the window masks (162) supplied to cover the windows
from the inside
. A high-quality masking tape should be used on
the inside of the body to mask off any stripes, panels, or designs that you wish to paint on the body. Use acrylic lacquer, acrylic
enamel, or any other paints recommended for Lexan (polycarbonate). Apply paint to the inside of the body. Remove the tape for the
next color and continue. Try to use darker colors first. If you use a dark color after a light color, apply a coat of white over the lighter
color before applying the darker color. This will help prevent the darker color from bleeding through the lighter color.
STICKERS
Cut the stickers from the sticker sheet (163) that you wish to apply to the body. Before removing the protective backing, find the
desired location. Remove the backing completely and reattach an edge of the sticker to the shiny side of the backing material. Using
the rest of the backing material as a handle, position the sticker and press firmly into place to complete its application.
Finishing the Body
Figure 63
Содержание XXX-T Matt Francis Edition
Страница 2: ......
