B A G D
9352, qty 1
right tranny case
9352, qty 1
left tranny case
3976, qty 2
3/8 x 5/8
unflanged bearing
3977, qty 2
3/16 x 3/8
unflanged bearing
6598, qty 2
3/8 x 5/8
bushing
6599, qty 2
3/16 x 3/8
bushing
1:1
6571, qty 1
drive shaft/gear
7669, qty 2
drive shaft
spacer
9360, qty 1
idler gear
ADD BUSHINGS OR BEARINGS TO
THE CASE HALVES
Cut the two #9352 transmission case
halves and the three #9352 spacers
from the runner.
Add bushings or bearings to each
case half.
1:1
9361, qty 1
idler gear shaft
6928, 6935*, qty 3
4-40 x 1
6572, qty 1
drive shaft
roll pin
6292, 6934*, qty 1
4-40 x 3/8
1:1
1:1
1:1
1:1
1:1
ADJUST THE DIFFERENTIAL
As you tighten the diff bolt, you will notice the T-
nut ears moving closer to the bottom of the diff hub
slot. This compresses the spring behind the T-nut.
The spring should be fully compressed at the same
time the T-nut reaches the end of the slot.
Caution:
Pay close attention to feeling when
the spring is fully compressed. Do not overtighten the
bolt. When you feel the spring fully compressed, loosen
the diff bolt 1/8 of a turn. No more, no less. Your diff
should now operate very smoothly when turning the
hubs in opposite directions. After you have driven the
car once, recheck the diff adjustment. Never adjust the
diff any other way.
INSIDE THE TRANNY
Install the right side diff assembly into the right case.
(Page 9, Step 3 will show you which diff hub is the right
side.)
Add the #7669 spacer to the #6571 drive shaft and put
both into the case.
Install the two bushings or bearings in the #9360 gear,
followed by the #9361 shaft. Insert the assembly into
the case.
Add the other #7669 spacer to the #6571 shaft and put
the case halves together.
OUTSIDE THE TRANNY
Screw the halves together with one
#6292 (6934*) bolt.
Insert the #6572 roll pin into the shaft
hole with your needlenose pliers.
Push the three #6928 (6935*) bolts
through, each with its own #7337 washer.
s t e p 5
T O O L S U S E D
1/16", 3/32"
s t e p 6
s t e p 7
10
1:1
center pin about shaft
9352
9352
9352
RIGHT
LEFT
6599, qty 2
3/16 x 3/8
bushing
1:1
9352
7669
6571
3977, qty 2
3/16 x 3/8
unflanged bearing
1:1
6572
9361
7669
6292
6928, 6935*
LEFT
RIGHT
7337, qty 3
washer, gold
1:1
7337
7337
7337
9360
REMOVE THESE
PARTS FOR:
Steps 6-7
T E A M
&
F . T .
B A S I C &
S P O R T
T E A M
&
F . T .
B A S I C &
S P O R T
6928, 6935*
6928, 6935*
