7
8) The device is distinguished by a high degree of output. During operation, this results
in a strong heat generation. Therefore no cables or other parts may adjoin the device.
If their insulation melts, there is the risk of a short circuit or fire.
9)
Removing
: Turn off the device. Remove the operating unit and place it into the case.
Clamp off the negative pole of the vehicle battery for the duration of the disassembly.
First remove the front frame of the device by inserting a flat object (e.g. the back of
the disassembly key) between the device and the panel to the right and left of the
short side of the frame and carefully levering the panel out towards the front. Then
insert the two disassembly keys into the openings on both sides of the front of the
device and slide these until the stop. Make sure that the protrusion on the
disassembly key points away from the device during the insertion. Slowly and
carefully pull out the device. Remove the cable and antenna from the device.
10) Make sure that no vehicle cable can cause a short circuit after the device has been
unplugged.
Operation of the Monitor
Open the monitor by briefly pressing the “OPEN” button. Now the monitor is opened
automatically and fixed in the flipped-open position. The monitor can be closed again by
pressing the “OPEN” button again. If the monitor doesn’t close as a result, it may not be in
the correct position. Then there will be an error message displayed.
Note:
Before beginning to drive, please familiarize yourself sufficiently with the device and avoid
longer entries during the drive for your own safety!
■
If the back of monitor touches dashboard or air-conditioner inlet et. after opening the
monitor .then setup TILT level in monitor TILT menu to prevent damage from repeat touching.
Any excessive force, improper use, or incorrect handing, which result to damage to the
monitor or TILT Mechanism is NOT covered under the normal warranty terms.
