Teac TD-9000T, Инструкция по эксплуатации

Страница: 15 / 20

15
Content Command Command No. Byte Parameter Note
Zone settings
Set zone number 7200 1
1 to 5
(resets to 1 when power turned on/off )
The zone set by this
can be changed
with the following
commands.
Enable zone 7201 1 0: Disabled, 1: Enabled
Zone range starting point 7202 4 0 to 99999
Zone range ending point 7203 4 0 to 99999
Load high limit (HI) 7204 4 ±99999
Load low limit (LO) 7205 4 ±99999
Displacement high limit (HI) 7206 4 0 to 99999 This can be set when
the X axis is set to
displacement.
Displacement low limit (LO) 7207 4 0 to 99999
Judgment method 7208 1
0: Constant comparison, 1: Sample,
2: Peak, 3: Bottom, 4: Peak-to-peak,
5: Average value, 6: Maximum,
7: Minimum, 8: Inflection point
Maximum/
minimum
Load difference (LOAD DIF.) 7211 4 ±99999
Scaling factor 7212 1
00 to 99 (input without decimal point)
(0.0 to 9.9)
Values higher than
9.9 automatically
rounded to 9.9.
Number of detections
(COUNT)
7213 1 1 to 10
Values higher than
10 automatically
rounded to 10.
Inflection point
(INFLECTION)
Detection starting load
(STARTING LOAD)
7220 4 ±99999
Detection extent A
(WIDTH A)
7221 4 1 to 9999
Detection extent B
(WIDTH B)
7222 4 1 to 9999
Load difference (LOAD DIF.) 7223 4 ±99999
Offset extent (OFFSET) 7224 4 0 to 99
Message communication (measurement data commands)
Content Command
Command
No.
Service Transmitted data (in word* units)
Zone display
Zone 1 300 R Start pos End pos Load(Lo) Load(Hi) Disp(Lo) Disp(Hi)
Zone 2 301 R Start pos End pos Load(Lo) Load(Hi) Disp(Lo) Disp(Hi)
Zone 3 302 R Start pos End pos Load(Lo) Load(Hi) Disp(Lo) Disp(Hi)
Zone 4 303 R Start pos End pos Load(Lo) Load(Hi) Disp(Lo) Disp(Hi)
Zone 5 304 R Start pos End pos Load(Lo) Load(Hi) Disp(Lo) Disp(Hi)
Measurement
waveform
Measurement range 305 R Start pos End pos
Load measurement
waveform (load)
310 to 319 R 1 block = 224 words* (10 blocks total)
Load measurement
waveform (displacement)
320 to 329 R 1 block = 224 words* (10 blocks total)
Load measurement time 330 to 339 R 1 block = 224 words* (10 blocks total)
Band waveform
Band waveform range 306 R/W Start pos End pos
Load band waveform
(low limit)
350 to 359 R/W 1 block = 224 words* (10 blocks total)
Load band waveform 360 to 369 R/W 1 block = 224 words* (10 blocks total)
o
Start pos and End pos units are not physical units. They are dot positions on the X axis. Values are in the image range (0–2239) on
the X axis.
*1 word is 2 bytes (little-endian)
2. Communication functions