Teac ER-LXRC1000, Инструкция по эксплуатации

Страница: 7 / 40

7
4-2. Back
A B C
A
TO LX-1000 external control input/output
connector
Use the included cable to connect this to the DIGITAL
CONTROL input/output connector on the back of
the LX-1000.
B
MEMO IN (mic input) jack
Connect the included mic here to record voice
memos.
C
STANDBY/ON switch
Press and hold this switch to turn the system on. Press
and hold it again to put the system into standby.
The light shows the status as follows.
Lit blue: Stopped
Blinking blue: Starting up
Unlit: In standby mode
4. Names and functions of parts
4-3. Turning the power on
Check the connections between the LX-1000 and
ER-LXRC1000 units, as well as their AC adapter connec-
tions. Then, press and hold the STANDBY/ON button on
either of them to turn them on.
The Home Screen will appear on the display.
4-4. Putting the system into standby
After confirming that the SD card is not being accessed,
press and hold the STANDBY/ON button on either the
LX-1000 or this unit to put them into standby.
ATTENTION
o
If the system is put into standby while data is being
written to the SD card, data recorded on it might
become unreadable.
o
Before moving this unit, stop power supply to the AC
adapter and the DC IN connector on the LX-1000.