Teac ER-LXRC1000, Инструкция по эксплуатации

Страница: 29 / 40

29
Deleting ID filters
Press the Delete all (F3) button to delete all.
To delete one filter, turn the VALUE dial to select it,
and press the Delete (F2) button.
Set All
This will apply the same baud rate, sampling point,
SJW, CAN FD, listen only and thinning out settings to
all ports. This does not affect terminator, ID filter and
maximum recording rate settings.
8-3-2-4. AO Amp settings
OUTPUT V RANGE
This sets the voltage output when the input of the
selected channel is 100% of the input range.
SELECT OUTPUT CH.
Measured values of the specified channel are con-
verted from digital to analog and output.
CHANNEL NAME
Set the output channel signal name.
Set All
Set the output voltage range and output channel
selections for every AO amp.
o
When a setting for one of the above items is
selected, press the ENTER button while pressing the
SHIFT button to set all AO amplifiers to the same
value for that item only.
8-3-3. PULSE SETTINGS
Set the pulse input (PULSE IN) on the front panel.
The setting procedure is the same as for module
settings.
1
Use the VALUE dial and the ON/OFF (F2) button
to put check marks next to the modules to use
for measurement.
2
Select the module to set first and press the
ENTER button to open the settings screen.
MODE
Select the pulse mode.
GATE
The pulse count is recorded during the gate time.
TOTAL
The total pulse count is recorded from the record
ready state.
PERIOD
The pulse period is recorded.
FREQUENCY
The pulse frequency is recorded.
RPM
The number of revolutions per minute is recorded.
8. Settings