USER GUIDE
/// ENTRELEC TERMINAL BLOCKS - HTP600 THERMAL TRANSFER PRINTER ///
412-121040 REV 1
57
MODULES INSERTION INTO THE PRINTER
NOTICE
Printing on a plate that has burrs on its edges can cause printing problems and can damage
the print head. Also, metallic particles adhering to a plate can damage the print head, so
handle and store plates carefully. Damage to the print head caused by printing on dirty plates
is not covered under the warranty.
Printing on plates that have dirt or grease (including skin oils) on the surface will result in
poor print quality
When aligning the guides with the width of the plate, align the leading edge of the plate with
the cleaner brush. If you push the leading edge of the plate into the feed opening, the printer
Automatically takes up the plate and positions it for printing
1)
Adjust the width guides to the plate sides.
Detach the Guide Screw
Insert the Module on the printer Plate
Set the Guides to the width of the Module
Fix the Guide screw
REMIND
If the width guides are too close together, the plate will not feed properly. It is important to
adjust the width guides so that the plate is not loose, but it moves smoothly to the left. If the
width guides are too loose, the plate will not be fed straight and yield poor print results.
Always make sure the guides are properly aligned with the plate.
