IDC Hand tool RAST 2.5 and 5
©2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
8/ 55
Operation Manual
744015-5
*Trademark. Other products, logos, and company names used are the property of their respective owners.
3.6
Adhere to the following instructions
3.6.1
General instructions
Observe the regulations for accident prevention and environmental protection for the country where
the product is used and at the workplace.
Exclusively use the IDC hand tool in good technical order and condition.
Check the IDC hand tool for visible defects, for example missing parts in set case or
broken parts.
You must generally not modify or retrofit the product.
Only use the product appropriate to the intended use described in this manual.
Person who assemble, operate, disassemble or maintain the machine must not
consume any alcohol, drugs or pharmaceuticals that may affect their ability to
respond.
Before putting the IDC Hand tool into operation, it is always important to check whether all devices
are at hand and functioning correctly.
The warranty only applies to the delivered configuration. The warranty will not apply if the product
is incorrectly assembled, not used as intended and/or handled improperly.
If the IDC hand tool is apparently damaged or do not work proper, you must send it in for repairs
(section 13.1 „Contact Information”).
3.6.2
During operation
Only persons who have been authorized by the operator may be granted access to the direct
operating range.
3.6.3
During disposal
For environmentally friendly disposal please observe the notes in section
11 ”Disposal”.
3.7
Obligations of the operator
The operator of the TE Connectivity Ltd. products is bound to provide for personnel training on a regular
basis regarding the following subjects:
Observation and use of the operating instructions and the legal regulations
Intended use and operation of the IDC hand tool.
