TE Connectivity FlexWave Prism, Руководство по установке

Страница: 44 / 50

Install the RF Module(s)
Page 42 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2013 TE Connectivity Ltd TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
c
Connect the LVDS Cables to the RF Module.
i
If available, connect the MOD N DIV LVDS Cable to the DIV receptacle of the lower RF
Module by inserting and sliding in until fully seated. If DIV receptacle is not available,
constrain the MOD N DIV LVDS Cable to accompanying cables using a tie wrap so it
cannot be pinched or prevent the PRU door from closing.
ii
If available, connect the MOD N PRIM LVDS Cable to the PRIM receptacle of the lower
RF Module by inserting and sliding in until fully seated. If DIV receptacle is not
available, constrain the N PRIM LVDS Cable to accompanying cables using a tie wrap
so it cannot be pinched or prevent the PRU door from closing.
iii
If available, connect the MOD N DIV LVDS Cable to the DIV receptacle of the upper RF
Module by inserting and sliding in until fully seated. If DIV receptacle is not available,
constrain the MOD N DIV LVDS Cable to accompanying cables using a tie wrap so it
cannot be pinched or prevent the PRU door from closing.
iv
If available, connect the MOD N PRIM LVDS Cable to the PRIM receptacle of the upper
RF Module by inserting and sliding in until fully seated. If DIV receptacle is not
available, constrain the N PRIM LVDS Cable to accompanying cables using a tie wrap
so it cannot be pinched or prevent the PRU door from closing.
NOTE: Full insertion can be recognized by an audible click as the LVDS Cable Connector locks into the RF
Module Receptacle. This can be verified by lightly pulling back on the LVDS connector while
making sure not to depress the release trigger. When fully inserted, the cable should not be able
to be removed from the receptacle.
d
Connect the Power cable to the RF Module.
i
Connect the Power Cable Connector to the PWR receptacle of the lower RF Module by
inserting and sliding in until fully seated.
ii
If available, connect the Power Cable Connector to the PWR receptacle of the upper RF
Module by inserting and sliding in until fully seated. If PWR receptacle is not available,
constrain the Power Cable to accompanying cables using a tie wrap so it cannot be
pinched or prevent the PRU door from closing.
NOTE: Full insertion can be recognized by an audible click as the Power Cable Connector locks into the
RF Module Receptacle. This can be verified by lightly pulling back on the Power Cable Connector
while making sure not to depress the release triggers on the ends of the connector. When fully
inserted, the cable should not be able to be removed from the receptacle.
Refer to the graphic that corresponds to the RF Module being installed in a dual‐slot:
•
Dual‐Bay Dual‐Slot RF Module: Figure 23 on Page 43
•
Dual‐Slot 40W RF Module: Figure 24 on Page 44 .