TE Connectivity FlexWave Prism, Руководство по установке

Страница: 34 / 50

Install the RF Module(s)
Page 32 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2013 TE Connectivity Ltd TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
4
Push the left edge of the RF Module back and into the PRU chassis until it can go no further, as
shown in the following graphics:
•
For Single‐Slot RF modules, see Figure 15 on page 32 .
•
For HDM RF modules, see Figure 16 on page 33 .
•
For Dual‐Slot RF modules, see Figure 17 on page 34 , which uses the Dual‐Slot 40W RF
Module as an example.
CAUTION! Make sure the RF Module is seated correctly in the Module shelf. Incorrect alignment of the RF
Module can cause the RF Module to fail due to overheating.
• The front edge of the RF Module should be parallel with the shelf above it.
• The Mounting Hook on the RF Module should be fully engaged with the Receiving flange on
the PRU chassis.
• If you later cannot shut the PRU door, verify that the RF Module is installed correctly.
Figure 15.
Seating a Single-Slot RF Module
Push the RF Module
back into the chassis
until it can go no further.
Single-Slot
RF Module