DANGER
STOP
409-5861
18 of 26
Rev B
To avoid personal injury, exercise caution when machine is connected to power supply and terminating machine is turned
on.
NOTE
i
Excess grease may drip down applicator if the grease is not removed from the ram slides, gibs, and frame. When
lubrication is complete, re-connect the power supply to the machine and turn on the power to the terminating machine with
the main power switch/circuit breaker. Select the JOG mode (Forward) operation (mode light must be ON); then press the
manual cycle button to lower the ram. Remove excess grease from the ram slides, gibs, and frame. Press the manual
cycle button again to complete the cycle and return the ram to the "fully retracted" position.
7. ADJUSTMENTS
The following adjustments are necessary to maintain the operating condition of the terminating machine and to
set up the machine after replacing parts.
DANGER
STOP
Before making any adjustments, ALWAYS disconnect the power supply to the machine. Turn OFF power to the
terminating machine with the main power switch/circuit breaker. If applicator is an air-feed type, DISCONNECT air lines to
valve located on the right side of the terminating machine.
7.1. Measuring Shut Height
The shut height is the distance between the bottom surface of the ram post adaptor and the top surface of the
terminating machine base plate. See Figure 12.
NOTE
i
To ensure optimum function of the shut height gage, make sure the gage is the same temperature as the terminating
machine before measuring shut height.
Figure 12
135.8±0.025 mm
[5.348±.001 in.]
Shut Height
