6
5.
Assemble two lugs on each bus bar, one on each side, using two hexagon bolts, four plain washers, two
helical spring-lock washers and two hexagon nuts as illustrated in Figure 5.
Figure 5: Two 10V Units Lugs Assembly
6.
Assemble bus bar insulator prior to output cover assembly. The insulator is flexible and could be opened in
its bottom side. Open the insulator and cover the bus bar by sliding it over the bus bar, from top to bottom,
as illustrated in Figure 6. Repeat for the second bus bar.
Figure 6: Two 10V Units Bus Bar Insulator Assembly
For recommended lugs refer
to
series Safety &
Installation Manual.
Not supplied.
Hexagon Nut, M10, Stainless Steel
Helical Spring-Lock Washer, M10, Stainless Steel
Plain Washer, M10, Stainless Steel
M10 x 25 Hexagon Bolt, Stainless Steel
Tightening torque: 220-265 Lbf-inch (24.9-29.9 Nm)
Bus Bar Insulator
