L200Y SLIDING GATE OPERATOR USER
’S MANUAL
12
Table 2 DIP-switch
(See Fig.9 terminal 18)
Position
DIP-switch
Function
1
ON
Programming / In this position the control board is in
programming condition, NOT USE condition.
OFF
Normal / In this position the control board can be normally used.
2
ON
Auto-close function and auto-close function of pedestrian mode
are available.
OFF
Both Auto-close function and auto-close function of pedestrian
mode are shut off.
3
ON
Limit switch mode is NC.
OFF
Limit switch mode is NO.
Set auto-close function (This feature can be selected to make the gate stay open for some
seconds before it automatically closes. The auto-close time can be adjusted to between 0
and 44 seconds.): please turn on the first and the second DIP-switch (See Fig.9 terminal 18)
to ON position. Press the remote control button (button 1, button 2 or button 3) that has
been programmed to open the gate (see
Verify open direction
section). Stop the gate at
any position by pressing the same button, wait for some seconds according to your
requirements (the range is 1~44 sec.), this period of time is regarded as
‘auto-close time’.
Close the gate by pressing the same button. Press the button again to stop the gate or the
gate will stop at its closed position automatically if the limit switch is reached. After this
setup is complete, return DIP-switch 1 to OFF position immediately. Thus the auto-close
function has been set.
Cancel auto-close function:
please turn on the first and the second DIP-switch (see Fig.9
terminal 18) to ON position. Press the remote control button (button 1, button 2 or button 3)
that has been programmed to open the gate (see
Verify open direction
section). Stop the
gate at any position by pressing the same button, wait until the gate close automatically (45
sec.). Press the same button to stop the gate or the gate will stop at its closed position
automatically if the limit switch is reached. After this setup is complete, return DIP-switch 1
to OFF position immediately. Thus the auto-close function has been cancelled.
Pedestrian mode:
Pedestrian mode can be used to open gate about 0.3~1.5 meters for
people pass through.
﹡
Set width of pedestrian mode: Please turn on the first and the second DIP-switch (See
Fig.9 terminal 18) to ON position. Press button 4 to open the gate (see
Verify open
direction
section), Wait until the gate travels the distance according to your requirements
(the distance range is 0.3m~1.5m or wait for 3~10 sec.), it is regarded as
‘the width of
pedestrian mode
’. Then press the same button/button 4 to stop the gate, wait for some
seconds (1~ 44 sec.). Close the gate by pressing the same button/button 4. Press the
same button again to stop the gate or the gate will stop at its closed position automatically
if the limit switch is reached. After this setup is complete, return DIP-switch 1 to OFF
position immediately. Thus the
width of pedestrian mode
has been set.
If you open the gate with button 4, the gate will stop at the expected position that you have
set.
