2800 Laura Lane • Madison, WI 53562 | 800.288.9383 • fax: 608.836.9044 | www.tcsbasys.com
14
15
UBIQUITY CONNECTION STATUS
This section displays the status of the connection between the QD2040c and the central server. You have three options
for the message that will appear here:
1)
Error
- No Route to Host -- means the unit does not currently have an Ethernet connection.
2)
Connected
-- means the unit is able to communicate to the Ubiquity central server BUT is not being matched up with a
specific Site, typically this indicates that the site is not initialized on the central server side yet, please contact TCS Basys
Controls to assign or initialize the QD2040c to a site
3)
Established
-- means the unit is communicating with the Ubiquity central server AND is ready to go. All Ubiquity
functions (monitoring, programming, alarming, etc.) should be available through the user interface at this point.
Clicking the green button with the arrow on it on the right side of the Ubiquity Connection Status title bar will refresh the
connection status
DEVICE
CONFIGURATION
CONTROLLER VIEW
This section allows you to see what controllers have been found by the QD2040c and view each controller’s address,
model, and communication status. The state field will show AUTO-DETECTED initially when found by the unit and
CONFIRMED once the controller has been recognized by the Ubiquity central server. This information allows the installer
to verify that each controller has been found by the QD2040c and is communicating with the local network. Clicking the
green button with the arrow on it on the right side of the Controller View title bar will refresh each controller’s status.
SYSTEM COMMANDS
In this section you are able to set a couple of system flags for the QD2040c itself. “Reboot Unit” sets a flag which will
shut off and restart the QD2040c within a 5 minute Cycle. “Check for Update” contacts the Ubiquity Central Server for
any updates relevant to its particular model number and software version. Once the update has been downloaded, it is
automatically applied, and the unit may reboot.
NOTE:
The “Check for Update” command requires that the QD2040c have Internet access to retrieve the update patch.
