01/2013
11
TCS TürControlSysteme AG, TCS Hotline Deutschland: +49 (0) 41 94/ 9 88 11 88
Subject to technical changes.
FAX: +49 (0) 41 94/ 9 88 129
Mail: [email protected]
PI_K30001-30004_uk 1A
Open and install the post
1.
Remove the 4 screws in the post roof with
the encluded allen key.
2.
Put down the post roof on a clean ground.
Ensure that the screws and the rubber
rings below the screws are not getting
lost!
3.
Loosen both knurled screws, which are lo-
cated in the inside at the post edge to free
the upper back panel
1)
.
4.
Push the back panel upwards out of the post.
Put it down on clean ground.
5.
Loosen both knurled screws which are locat-
ed inside at the level of the upper edge of the
lower back panel. To do this, you have to
grab through the oval hole.
6.
Push the lower back panel upwards until a
small grub screw can be seen above the oval
hole.
!
Secure this back panel.
Turn out the grub screw with a small
screwdriver until the back panel cannot
slipe down!
7.
Break out an opening in one of the connec-
tion cavity wall boxes for the connection ca-
ble which is provided by the customer.
Guide the connection cable through the
opening in the cavity wall box to the connec-
tion terminals.
8.
Fix the cable with the clamp (pluggable part,
enclosed).
9.
Connect the wires to the connection termi-
nals according to type label.
Connect the provided cable with the connec-
tion terminal functional earth.
1) The communication posts with a length of 1300 mm are
equipped with a back panel made of one part.
The steps 5. and 6. can be omitted.
Shown is the K3000x, 1700 mm
knurled screw
post roof
upper
back panel
lower
back panel
connection
terminals
connection
terminal
functional
earth
grub screw
clamp, strain
relief
