1-27
1.4 PRE-OPERATION INSPECTION
Component
Item to be checked
Checking procedure
Engine
①
Oil level.
②
Engine oil contamination.
③
Exhaust sound and color.
(A) Remove dipstick and wipe its end with clean cloth.
Reinstall and keep it for about 1 minute. Remove it
to check oil level.
(B) Check for contamination of oil on the dipstick.
(C) Start engine and check exhaust sound and color.
Radiator
①
Cooling water level.
②
Cooling water leakage.
(A) Check water level in reserve tank visually.
(B) Check for water leakage from radiator or rubber
hose.
Fuel tank
①
Fuel level in fuel tank.
(A) Check the fuel indicator on the dash panel.
Clutch
①
Clutch pedal freeplay,
operation and slipping.
(A) Press clutch pedal until some resistance is felt to
check for freeplay (normal range: 0 - 5 mm).
(B) Press clutch pedal to the bottom to check for
operation.
(C) With parking brake applied, let up on clutch pedal
while stepping on accelerator pedal to check for
slipping of the clutch.
Master cylinder
(brake oil tank)
①
Brake oil level.
(A) Check brake oil level in reserve tank.
Service brake
①
Brake pedal freeplay and
braking effect.
(A) Press brake pedal until some resistance is felt to
check for freeplay (normal freeplay: 10 mm).
(B) Press brake pedal to the bottom to check clearance
between brake pedal and floorboard surface. Check
also for spongy brake, or air trapped in the system.
(C) Drive slowly and press brake pedal to check for
braking effect and uneven braking.
Parking brake
①
Operating force and
application.
(A) Pull the lever to the full to check that the lever is
properly locked.
(B) Operating force should be between 200 to 250 N {20
to 25 kgf}.
Tire
①
Tire inflation pressure.
(A) Check tires for inflation pressure visually or using
a hammer.
(B) Check treads and side walls for excessive cracks,
damage or undue wear.
Steering wheel
①
Excessive play or
looseness.
(A) With the engine running, turn steering wheel right
and left to measure how far it moves before the
wheels begin to turn (normal play: 20 to 30 mm).
(B) Move steering wheel up and down, and back
and forth to check bearings for looseness and
horizontally to check main shaft and steering
column rubber and bushing for installation.
Содержание FD35C9
