TCM FD35C9, Руководство по ремонту

Страница: 25 / 291

1-17
1.2 BASIC SERVICING KNOWLEDGE
1. Installing bearings
When installing a bearing onto a shaft, tap its inner
race with a mallet as shown in Figure 1.1. When installing
a bearing into a case, tap its outer race.
When removing, use the same procedure as for
installing.
2. “O”-rings
①
Use “O”-rings free from molding fault or damage.
②
Clean “O”-rings and their mounting area and apply grease or hydraulic oil to them.
③
When installing “O”-rings, do not expand them so excessively that they suffer permanent deformation. Also
do not roll them when installing; otherwise they might stay twisted, causing oil leakage.
④
When using an “O”-ring and back-up ring as a set,
such as when hydraulic pressure is high, position the
“O”-ring at the side which receives the oil pressure.
3. Oil seals
①
Oil seals should be installed with the seal lip pointed toward the lubrication or hydraulic oil.
②
When installing an oil seal on a housing, apply a thin coat of packing cementing agent on the oil seal outer
ring and inside the housing to prevent oil leakage through the fitting area. It is recommended to use a
suitable jig to apply uniform pressure when mounting oil seals.
Fig. 1.1
Installing bearings
JIG
Fig. 1.2 “O”-ring location
Pressure
Fig. 1.3 Installing Oil Seal
JIG JIG
JIG