TCL 55P6US, Руководство по обслуживанию

Страница: 11 / 39

Test and Alignment Specification for MS6586 Series
Page 6 of 22
are mandatory OUI entries structure to prepare DSM-CC carousel image format:
- export CUST_OAD_OUI 0x001C50
- export CUST_OAD_HW_MODEL 0x5395
- export CUST_OAD_HW_VERSION 0x0000
- export CUST_OAD_SW_MODEL 0x0001
- export CUST_OAD_SW_VERSION 0x00

OAD reflashing is managed within 4 steps operation: multiplex detection, DVB transfer, flashing and warm-start.
1.3. UART & IR Parser
To use both UART and/or IR parser, TV has to be set in Factory mode with its USB port well connected to suitable
UART device or an IR emitter devic
e correctly facing up TV (see below “Product Assembly - section 2.0” how to
activate “Factory key”).
The UART parser engine is enabled by sending following command “
0xE2
” from host to TV within following presets
115200 / 8 / n / 1 .
Once initialized, “
PS
” caption is toggle displayed on bottom left screen (“S” like Serial).
To communicate with TV depending on SIACP revision layout implementation, you need to fulfill UART/IR
commands protocol and format described on enclosed SIACP requirements document (rev. v3.9).
1.4. Project ID Modification
There are different IDs stored in the eMMC depending on different Panels
settings and Models features, but there’s
only one key branching Project ID that includes all.
So, it’s not recommended to modify Panel ID with Hyper terminal as
other ID features may not change!
To modify Project ID, you need to go through
“
Service menu

Project ID-->Project ID
”, then spin left or right with
RCU “◄
/
►” keys to chose suitable ID (Project name is dynamically refreshed).It is necessary to press “OK” key for
saving the setting.
See Appendix
⑸
“
How to change Project ID with RCU
”
See below is the ProjectID table for reference:
MODEL-EU ProjectID PanelID Panel Name MODEL-EU ProjectID PanelID Panel Name
U43P6006 1 1 LC430EGY-SJM1
U43P6006 2 2 T430QVN03.0
U55P6006 3 3 ST5461D07-8
U49P6006 4 4 ST4851D03-3
U65P6006
5 5
LSC650FN04-H/-J
Note
② :M
ore and more project ID will be added in the future.
1.5. Functional Test
Once the boards (chassis, KB, IR, PSU…) and the panel are well interconnected, plug all external generator
devices to relevant below inputs/outputs using respective test patterns format to check picture and sound quality:
Source Test Signal Test Pattern
Analog /Digital Tuner
(VHF/UHF & CATV)
RF cable generator
2D - Movie 1280x720
2D - Static Picture 1920x1080
1. Frequency Range: full band