12
6. Pour out the dispensed water each time to ensure that the container does
not overflow.
Once completed, the middle coffee button lights up
again and the indicator light flashes red and yellow.
7. Clean the water tank, used capsule container, drip tray, grid and coffee spout
as described in the section “Cleaning”.
Rinsing phase
8. To start the rinsing phase, rinse out the water tank using fresh water and fill
it with cold tap water to the MAX mark.
9. Place an empty container (at least 250 ml) beneath the coffee spout.
10. Press the middle coffee button to start rinsing.
The indicator light flashes 2x yellow and 2x red
alternately.
11. Approx. 500 ml water will be rinsed through the system. Keep an eye on the
container and empty it before it overflows.
12. Once completed, the middle coffee button lights
up again and the indicator light flashes red and
yellow alternately.
Press the middle coffee button.
The descaling procedure is completed.
All three coffee buttons flash. The machine is heating
up to brew coffee.
After a long period of non-use
If you will not be using the machine for a prolonged period, e.g. when you go on
holiday, we recommend for reasons of hygiene that you should remove the water
from the machine’s pipes. Proceed as follows:
1. Press the On/Off switch to switch off the machine.
2. Place a container beneath the coffee spout.
3. Fold down the lever if necessary.
4. Empty the water tank and reinsert it.
5. Press and hold the three coffee
buttons simultaneously and, in
addition, press the On/Off switch
to switch the machine on.
6. Release the buttons again.
The indicator light flashes red.
The pump transports the remaining water out of the
pipes of the machine. It stops automatically as soon
as there is no more water inside.
The residual water runs into the container beneath
the spout.
A signal sounds and the indicator light continues to flash red.
7. Press the On/Off switch to switch off the machine.
8. Fold back the lever to allow the pressure in the system to subside. A little
more water will drip from the spout.
9. Then fold down the lever again to close the capsule compartment.
When you wish to use the machine again at a later time, proceed as described in
the section “Initial operation – Prior to first use”.
