Procedura programmazione Serie NEOS Rev. 1.0 06/19
–
IT / EN
4
3-
Before connecting the PicKit3 device to the charger, make sure that the connection PINs inside the charger are clean and not covered by
the siliconic resin or any other thing. In case the PINs are dirty or there is a bad connection with the PicKit3 programmer and the
charger, the programming procedure might be compromise resulting in a programming error.
4-
Proceed with the connection of the PicKit3 programmer as shown in the below pictures.
IMPORTANT: if the connection is wrong, the program will not be able to find any device connected and will signal error.
5-
Open the programming file based on the module of the NEOS Series
1936 ---> Mod. 1-2-3-4 1938 ---> Mod. 0 45k80 ---> Mod. 5
The MPLab software will launch with the preset parameters for the microprocessor installed inside the charger.
Make sure that the color in reference to the arrow is as in
show in the picture above. Leave 1 PIN out on the left of the
connector.
