Procedura programmazione Serie NEOS Rev. 1.0 06/19
–
IT / EN
3
The procedure to program the charging profile of the NEOS Series shows in detail how the change the profile based on the charging necessity.
TCE Group Srl suggests to follow every step meticulously and with the utmost attention since the charger might not work properly in case of
error made by the user during the programming.
In case of wrong pr
ogramming, it is advised to contact TCE Group Srl and request assistance. Our contacts can be found on our “Contacts” section
on our
website
Before beginning the procedure, make sure to:
- Have a PicKit3 programmer
- Have the Software MPLAb V.8.86 installed on the PC
- Have an internet connection in the PC used for the programming (the programmer might need to download the firmware to be able to proceed with the
programming)
- Have a screwdriver with a PH1 head to avoid damaging the screws and make it unusable
PROCEDURE
1-
Before doing any operation on the charger, make sure both the DC and AC plugs are not connected.
2-
Turn the charger upside down and remove the screws on the back.
IMPORTANT: make sure to not lose any of the removed screws because the IP67 protection might be compromised in case of use of a
different type of screw.
