TC Electronic REVERB 4000, Руководство пользователя

Страница: 25 / 61

23
Basics
Navigating the TC Icon Software Editor is easy
as soon as a few basic elements are explained.
Generally:
• Press the top-tabs to do primary selections.
• Press the side-tabs or elements to do
secondary selections.
• Press parameter value fields to instantly
assign parameters to Fader 6.
• Adjust values using Faders 1-6.
• The TC Icon symbol key in the upper left
corner switched between two main modes:
- Setup/Select pages for main system
operations and
- Operation pages that are specific for the
connected units.
(also see the LINK explanation on next page)
Unpacked and ready
• Connect according to illustrations on pages
10/11.
• Install software according to explanation on
the previous page of this manual.
• Power up the Reverb 4000 and start the TC
Icon software on your computer.
• Go to the Setup/Devices/Select page.
• Press the DETECT key. The TC Icon Editor
will scan the system and find the connected
units.
• When the connected Reverb 4000 is
detected, assign the unit to one of the eight
shortcut keys in the right side of the display,
by pressing one of the eight keys (see
above). Any key will do. When several units
are connected this page serves as a
convenient organizer for the entire system.
• Go to the Select page (top-tab), and you will
see a screen similar to the one below
depending on number of connected units and
in which locations these are assigned.
• Press the large Reverb 4000 key.
• TC Icon now retrieves data from the
Reverb 4000.
• When ready you will see the Main operating
display.
• GO
THE TC ICON EDITOR - QUICK START