31
Why make a Master Fader?
If a fade is performed before the Finalizer Express, the Compressor will try to increase the level as the fader decreases. To
avoid this problem, fades must always be done after the Finalizer Express. The Master Fader makes it possible to perform a
manual fade on the very output of the Finalizer Express and you thereby keep your fade in digital domain and ensuring perfect
tracking of left and right.
Connecting and Calibrating the Master Fader
- Connect the Master Fader to the External Controller jack of the Finalizer Express.
- Press and hold the BYPASS key while powering up.
- Use the ADJUST “UP” cursor to select self test no. 10, which is the calibration menu.
- Press the FINALIZE SOFTCLIP “ON” key - an arrow up symbol will then be displayed.
- Move the Fader to max position - the cable end of the fader. To compensate for mechanical tolerances move the fader back
slightly.
- Press FINALIZE SOFTCLIP “ON” key to confirm - an arrow down symbol will now be displayed.
- Move the Fader to min position. To compensate for mechanical tolerances move the fader up slightly.
- Press the FINALIZE SOFTCLIP “ON” key to confirm.
- The Master Fader is now calibrated.
- Power Off/On.
Activating the Master Fader
To activate the Master Fader as External Controller press the FADER key in the Fade In/Out section.
The Master Fader controls the digital fader of the Finalizer Express.
Cables and lengths
The Master Fader uses standard mono jack cables. The cable can be extended using the jack to jack adapter, and can run at
cable lengths up to 25 meters. Remember to recalibrate after extending the cable.
MASTER FADER
