Changing video transmitter settings
On the underside of the XRACER is a slot to access the menu button and two status LEDs for the VTX.
In the menu there are categories and setting entries. Pressing the button for 3 seconds will toggle between
categories, pressing it for a short (1 second) press toggles between settings. To enter the menu, hold the
button for 3 seconds. LED colors will signal the state of the menu, for an overview see the following table.
Channel select mode
Enter menu by pressing the button for 3s. Red LED will flash 1 time. Select channels by simple short presses.
Band select mode
Press the button for an additional 3s. Red LED will flash 2 times. Select band by simple short presses.
Unlock and power select mode
The default VTX power level is 25mW and is fine for all close proximity flight where there are no other FPV
pilots around. To change this value you need to unlock the VTX.
(FOR HAM USERS ONLY!) To unlock, press button for 20 to 25 seconds. The Red LED will flash 3 times to
confirm. You have unlocked the video transmitter for use with all frequencies (see frequency table below).
The power select mode is now accessible. Once unlocked, you can select the power level according to the
table below. To lock the transmitter, go back into band select menu and press the button for 20 to 25 seconds
again.
Saving settings
Press button for 3 seconds. Blue LED will turn on, settings are saved and it will exit the menu.
8
