Model LR-416B, LR-165A, & LR-25B Hoist Installation and Operation Manual
Stock No. 036257
Page 9 of 22
NOTE
:
The hoist saddle must set directly on the truck frame. If rivet interference is
encountered, counter sink the rivet head into the hoist saddle.
9.
Position and secure the liner (sleeper) to the truck frame. The LR-416B or LR-165A hoist
requires at least 5 3/4" of clearance above the truck frame. As an example, if 4" long beams
are on the truck body, a liner of at least 1 3/4" will be required to gain enough room, 5 3/4", for
mounting the LR-416B or LR-165A. Similarly, a LR-25B requires 7 1/2" of clearance.
10.
Position the body with the long beams (just long beams if they are separate from the body)
onto the truck frame.
NOTE
:
A clearance of at least 2" is required between the truck cab and the closest point on the
truck body.
11.
Position the rear hinge brackets against the long beams. Once in position, weld the rear hinge
brackets to the body long beams as shown in Figure 6.
12.
Slide each of the lifting shafts all the way against the inside of the long beam. Weld the lifting
shaft angles to secure the shaft to the long beam as shown in Figure 7. With the shaft secured,
slide the lock collars against the hoist lifting tube and lock them there by tightening the set
screw (see Figure 4 & 7). Torque the setscrew to 24 ft-lb.