Model LR-416B, LR-165A, & LR-25B Hoist Installation and Operation Manual
Stock No. 036257
Page 16 of 22
"LUBRICATION"
IMPORTANT:
All grease fittings should be greased at least twice annually. Refer to Figure 12 for
grease fitting locations. Failure to grease hoist will result in hoist failure. Hoist failure
due to lack of grease is not covered by the warranty.
IMPORTANT:
Refer to installation and operation manual of the hydraulic system for hydraulic
system lubrication instructions.
1.
Grease all of the grease fittings in the hoist frame itself. Apply grease until excess grease can
be seen coming out the ends of the tubes. Refer to Figure 12 for grease fitting locations.
Replace any missing or broken grease fittings.
2.
Grease the two grease fittings in the truck rear hinge.
3.
Check oil level in the pump reservoir every time the oil is changed in the truck engine.
REMEMBER
keep the oil clean. An annual oil change can prevent contaminants from
ruining your pump and hoist cylinder.
FIGURE 12A:
LR-416B
GREASE ZERK
LOCATIONS
7 ZERKS TOTAL
