Model LR-416B, LR-165A, & LR-25B Hoist Installation and Operation Manual
Stock No. 036257
Page 7 of 22
"INSTALLATION INSTRUCTIONS"
1.
Mark the location for the rear hinge. This location should be immediately behind a truck cross
member, approximately 32" behind the center of the rear axle on single axle trucks. Refer to
Figure 1 for the specific hoist model you are installing.
2.
Referring to Fig #2, cut a notch as shown.
3.
Position the rear hinge angle in the notch cut in Step 2. The rear hinge angle is 37 3/16" wide
and should be centered side to side in the notch as illustrated in Figure 3. Weld the rear hinge
angle to each of the truck chassis frame rails.
NOTE:
This hinge assembly is designed for a truck longsill spacing of 34" and is not
recommended for any other width.
