- 15 -
Wave form
The signal form delivered to the “OUTPUT PORT“ can be switched from AUTO to SINE, SQUARE
HALF WAVE (DC-OFFSET), SQUARE FULL WAVE, SMART or OFF with successive touches on this
icon. The setting AUTO delivers SQUARE HALF WAVE (DC-OFFSET) signals with frequency values
below 65000 Hz and SINE signals with values above 65000 Hz. Please note that the DUO outputs on
connector PP deliver sine waves.
WOBBLE
If WOBBLE is activated the software asks for a value to be used to swing the
signal above and below the target frequency. A value of 0 deactivates the
feature. The background color of the button changes to green when activated.
Amplitude
If the signal form SQUARE or SINE is selected, the signal amplitude to be used can be adjusted with
touches on the horizontal slider. The maximum value is 100, the minimum value 0. The amplitude
value is global and valid for all programs of the “123” or “DUO” section.
How to start, pause, or stop a program
Touch the button
START
to start a program.
Touch the button
PAUSE
to initiate a pause of a running program.
Touch the button
STOP
end the program. .
Important: Whenever a frequency is selected, the signal is simultaneously sent to the output
and the PowerPort.
Envelope
If ENVELOPE is activated, and the signal form is SQUARE or SINE wave on single channel output
“OUT”, the amplitude will oscillate slowly between 0 and the value assigned to the frequency.
The background color of the icon changes to green when activated
